Saturday, September 6, 2014

Building the lefting bar for the Tormach PCNC 1100 Series 3




 


 





Steel Eyebolt 1/2"-13 with shoulder for lifting P/N 3014T254
3-Each Full Thread T-Slot Nut 1/2"-13 for 5/8 Slot P/N 94750A584
2 Each 1/2"-13 x1" Long Hex Bolts
2 Each washers for 1/2"-13 Hex Bolts




Measuring length for the chain





Posted by at

3 comments:

  1. SpencerMarch 23, 2016 at 8:51 PM

    This is a great idea. Did it end up being a lot cheaper? Not sure how much a steel plate like that would run.

    ReplyDelete
  2. DavidMarch 23, 2016 at 9:06 PM

    Hello Spencer, Yes because I made 2 one for me and one for a friend. I picked up the plate a a local metal supply place, and they punched the holes in both plates for five usd.

    ReplyDelete
  3. UnknownMarch 24, 2016 at 6:55 AM

    How did you know where to put the holes? Is there a sketch out there or did you just eyeball it?

    ReplyDelete

Subscribe to: Post Comments (Atom)