Tormach PCNC 1100 Series 3
Friday, April 3, 2015
Tormach PCNC 1100 Pulley Balance
Removing the Spindle Motor
Spindle Motor pulley after balance
Spindle
pulley after balance
Power Draw Bar spindle nut after balance
Sunday, February 22, 2015
Tormach PCNC 1100 Deluxe Stand Coolant Pump Pinched Wire
YDB-12TH COOLANT PUMP
Saturday, January 10, 2015
Granite surface plate for measuring TTS tooling height
Granite Surface Plate 9" x 12" x 2" A Grade
Item #
144838
Knowing someone who can cut a hole in the Rock
Priceless
Finished Hole
TTS Tooling fits
Saturday, September 27, 2014
Power Draw Bar Install Tormach P/N 31706 for PCNC 1100 Part 9 - TTS Parking Tool
The power draw bar install manual recommends the following:
"
It is NOT recommended to allow the power draw to reside
in the clamped position with no tool holder in place
"
"
This may put undue stress on the TTS collet.
"
So rather than leave a TTS tool holder in the TTS collet when the machine is not in use I made a
TTS
parking tool
Saturday, September 6, 2014
Building the lefting bar for the Tormach PCNC 1100 Series 3
Steel Eyebolt 1/2"-13 with shoulder for lifting P/N 3014T254
3-Each Full Thread T-Slot Nut 1/2"-13 for 5/8 Slot P/N 94750A584
2 Each 1/2"-13 x1" Long Hex Bolts
2 Each washers for 1/2"-13 Hex Bolts
Measuring
length for the
chain
Older Posts
Home
Subscribe to:
Posts (Atom)