A friend suggested that I check to see if the coupling's were centered.
Thanks for the heads up Kaz. What follows is what I found.
This is the position of the X Axis Motor Coupling Before Centering
Thanks for the heads up Kaz. What follows is what I found.
This is the position of the X Axis Motor Coupling Before Centering
You can see the Motor Shaft position in the Coupling
Coupling Screws were loosened using a 1/4" drive 3mm Hex Driver Bit
The coupling was moved to center the Motor and Lead Screw Shafts in the coupling
Coupling Location after Centering
M5x20 Socket Head Cap Screws were Torqued to 50Kg Cm
No comments:
Post a Comment